SOLO 250 PR-2255 This product manual contains important information about the safe installation and use of this projector. Please read and fol
solo 250 manual_last revision_en.doc 10/16 If the projector’s lens becomes damaged or broken it should be replaced. If the lamp becomes damaged or
solo 250 manual_last revision_en.doc 11/16 VOLTAGES: 100/120/200/220/230/240V AC, 50Hz or 60Hz To Order. POWER CONSUMPTION: 400
solo 250 manual_last revision_en.doc 12/16 LIGHT OUTPUT ELECTRICAL DIAGRAM
solo 250 manual_last revision_en.doc 13/16 NO. NAME PART NO. REMARK 1 TRANSFORMER 040030301 20V 50W / 230V 300W 2 THERMOSTAT 190010065 75℃/10A /
solo 250 manual_last revision_en.doc 14/16 To be carried out by qualified engineers only The power input settings of the SOLO 250 may be changed t
solo 250 manual_last revision_en.doc 15/16
solo 250 manual_last revision_en.doc 16/16 PR LIGHTING LTD. No. 571 Yingbin Road, Dashi, Panyu, Guangzhou, China Post-Cod
solo 250 manual_last revision_en.doc 2/16 SAFE USAGE OF THE PROJECTOR 3 INSTALLING THE PROJECTOR 4 FITTING THE LAMP 4 POWER SUPPLY – MAINS 5 CO
solo 250 manual_last revision_en.doc 3/16 When unpacking and before disposing of the carton check there is no transportation damage before using th
solo 250 manual_last revision_en.doc 4/16 The projector should be mounted via its bracket using 2 M12 bolts. The bracket itself attaches to the un
solo 250 manual_last revision_en.doc 5/16 Use the plug provided to connect the mains power to the projector paying attention to the voltage and fre
solo 250 manual_last revision_en.doc 6/16 5-PIN AND 3-PIN CONVERSION SOLO 250 uses 3-pin XLR plug / socket. If your controller uses 5-pin XLR plug / s
solo 250 manual_last revision_en.doc 7/16 PROJECTOR DMX START ADDRESS Each SOLO 250 must be given a DMX start address so that the correct projecto
solo 250 manual_last revision_en.doc 8/16 The SOLO 250 uses 10 DMX channels. They are listed in the following table. CHANNEL DMX VALUE DESCRIPTI
solo 250 manual_last revision_en.doc 9/16 STAND-ALONE MODE To operate the projector without connecting a controller, enable a combination of setup
Commentaires sur ces manuels